Transit Sliding Door Adjustment

With the aid of another technician push the front of the sliding door until it aligns with the b pillar and tighten the lower arm outer adjustment screw.

Transit sliding door adjustment.

Over estimating the movement required tends to be the winning theme when adjusting the door. Move the door in whichever direction you feel it needs to be moved up or down are most likely and tighten the bolts with the door in its new position. Turning this screw raises or lowers the roller. Remove the scuff plate.

Tighten the lower arm inner adjustment screw. If the door becomes even harder to open turn the screw in the opposite direction. If the gap between door and that pillar is too large it should also be too narrow at rear edge of door to move whole of door forwards in its frame support the rear edge of the door mark around the centre roller where it sits on door loosen the mounting bolts to door tx40 i think move the roller towards rear of van then tighten bolts this will push door forwards in closed position. Hi i am driving a ford transit from 2008 and i keep getting a door open signal from the sliding door when i drive over bumpers or around curves even though the door is closed.

Loosen the mounting bolts with a socket wrench on one side of the hinge either the door side or the body side. When i lock the doors with the light on it closes but the lights stay on and the horn goes off. Not worth adjusting while closed you have to fight against the doors seals and it s just too much work. Door open warning from sliding door.

Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends. Make estimates of the adjustment required while the door is 1 2 open get a helper if needed and keep at it. Sliding door servomotor controller sliding door right for ford transit vi vii from 2000 2014 new goodsoem reference number for comparison 4128844yc1514b287aasuitable for ford transit vi vii from 2000 2014.