Went to the dealer today and asked about the door lock programming.
Toyota automatic door lock programming.
It will beep twice if you re reactivating the system.
My rig is 2002 limited.
Automatic door locking and unlocking systems.
Close all doors and switch the ignition to the on position.
Shift the shift lever to p or n and press and hold the driver s door lock switch for approximately 5 seconds and then release.
Use the same procedure to cancel the function.
Just perform these steps to program the door locks.
Do not start the engine.
Press the unlock button then press lock again.
Automatic locking and unlocking modes step 1.
This adjustment is not really a repair but will help you to fix the issue if the car is set in a mode that you do not like.
The horn will beep once to tell you that auto lock was deactivated.
You can control the behavior of the automatic door locking feature on the toyota corolla.
Service department indicated that some models could not be programmed following the owner manual.
All toyota vehicles with an automatic transmission and power door locking system have a feature that allows the driver to select an automatic locking and unlocking sequence for the doors.
Toyota corolla owners manual.
The shift lever and switch positions corresponding to the desired function to be set are shown in the following table.
Turn the ignition back to off and listen for the horn to beep one time confirming that the programming was accepted.
There are four modes from which to choose.
Service had to do the program from diagnostic computer for 50.
If you own any recent toyota model that has power locks and an automatic transmission you have the ability to change the sequence for the locking and unlocking of the doors as determined by the current mode.
When the transmission is pulled from park all the doors will automatically lock.