Torsion Bar Garage Door Installation Instructions

Flying off can damage cars other property or even a person who is in the garage when it happens.

Torsion bar garage door installation instructions.

8 align the lhr rear upper track to the standard track so that the gap between the lhr front and lhr rear upper tracks is not greater than 1 8. Residential sectional garage door installation instructions series 321 323 327 329. For extension spring installation go to page 7 of these instructions. After the springs are installed proceed to page 6 step 35 of the door installation instructions to finish the installation.

With locking pliers clamped on the torsion tube winding bars are used to wind the springs tighter to increase tension. Mark the position on the standard track through the lower hole in the front splice plate connected to the lhr rear upper track. When two springs are used both sides should be adjusted the same. Supplemental instructions torsion spring installation this is a supplement to the residential garage door instructions referred to as the manual.

Securely mounted hardware and rails. For all other information and safety warnings concerning your garage door see the manual. Make sure that the bearing is inside the stationary cone. When torsion springs break they don t fly off like extension springs can.

Follow the track bolt placement figure. For torsion spring installation go to page 7 of the door installaton instruc tions. In the end scott got the door that he wanted installed along with a great liftmaster garage door opener. Read the information in both.

Torsion spring brackets should be firmly mounted to the wooden header above the door. Tension is reduced by removing turns. Installation of rear torsion spring system. Insert the bolts in the stationary cones of the new torsion spring and insert the bolts in the slots on the spring anchor bracket.

Finger tighten nuts on bolts until the stationary cone is flush against the center bearing plate. Roller track support brackets and the opener should be securely bolted to the rafters. For instructions on how to install a new garage door opener see how to install a garage door opener. It covers installation of torsion springs step 14 of the manual.

To adjust torsion spring tension the door is locked in the down position.