Tools Needed To Change Torsion Spring On Garage Door

Use a metal rod to stick in the first notch of the cone.

Tools needed to change torsion spring on garage door.

A failing unbalanced or poorly matched spring. Look for a reddish cone on the torsion spring. An unbalanced door is a sign of. Tools and supplies needed to replace torsion springs.

Next pull down on the winding cone with a winding bar. Press the spring into the mouth of the jaws of the wrench with your thumb and rest the other end of the wrench on the top of the door. Two 1 2 inch x 18 inch winding bars never use screwdrivers sturdy ladder. Torsion springs need to provide enough force to equal the weight of the door.

You will need to adjust your pipe wrench a couple of times to get a good grip on the spring. When the door is closed and at rest the torsion spring stores enormous amounts of energy and when you want the door to open the spring helps by uncoiling and releasing that energy. Replacing torsion springs is the more difficult and potentially dangerous task. Rotate the drum to wind the cable into the winding grooves.

9 16 1 2 and 7 16 inches 3 8 inch square head or eight point socket. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. Torsion springs and garage door weight. Gather the supplies and tools needed for changing the springs safely.

Replace torsion garage door springs by following these steps. Most hardware stores sell 1 2 x 36 steel rods that can be cut in half. Ruler or tape measure. Here are the tools you need to replace a broken garage door torsion spring.

Two winding bars. Prime line gd 52238 torsion spring winding rods the only tools recommended for adjusting or replacing garage door tension springs 1 2 diameter x 16 long round steel rods pack of 2 4 6 out of 5 stars 218 12 04 12 04 0 08 oz get it as soon as thu aug 27. Torsion springs store energy by coiling tightly as the door as the door closes. How to adjust a torsion spring garage door.

You need these to remove tension from the existing springs at the beginning of the project and add the proper tension to the replacement torsion springs at the end. The cone is on the torsion spring on the left side away from the center of the garage door. Leave the locking pliers in place and repeat the tightening procedure on the other side. Torsion springs vs extension springs.

The rod will need to be at least 18. In addition to the torsion springs you ll need a minimum of one or two 10 vise grips an adjustable wrench and two 1 2 x 18 winding bars. Pull the cable as tight as possible before tightening the setscrews.